Skip to Main Content
Software Ideas

Welcome to the Boise Cascade Engineered Wood Products Software Ideas Portal! 

We welcome your EWP Software suggestions and ideas.

ADD A NEW IDEA

All ideas

Showing 249 of 249

Display the linked support relationships

I want to see the linked support relationships between members in the project so that I can quickly identify which members are supported by other members.
over 7 years ago in BC Calc 0

Create the linked support relationships in BC Calc when I send member from BC Framer

I want to maintain the load transfer and support relationships from BC Framer when I send to BC Calc.
over 7 years ago in BC Calc 0

Link one member support to more than one member

I want to link the support of one member to more than one supporting member to model the case where a run of otherwise identical joists have a different support condition.
over 7 years ago in BC Calc 1 Will not implement

Allow custom width for linked beam supports

When two joists abut over a beam, I want to link both to the beam and have the proper bearing length used for design.
over 7 years ago in BC Calc 0

Allow a send to Calc from BC Framer without impacting the current analysis

BC Calc currently permits only one active session at a time per browser. Note: Incognito or In-private mode permits the user two concurrent sessions if needed.
over 7 years ago in BC Calc 0

Display the simplified loading on BC Calc reports for members from BC Framer

Provide the option to display the simplified loading view on the member report in BC Calc, which is the same view used in BC Framer reports. Currently the "all loads" view is used in BC Calc.
over 7 years ago in BC Calc 0 Planned

Change the tab order in dialogs so that reference right checkbox isn't between the start and end fields

I want to input the start location for a load, hit the tab key once and input the end location, not hit the tab key twice to skip over the reference right checkbox.
over 7 years ago in BC Calc 0

Cantilever Design Parameter Overide

As a User, I would like to have the ability to override the cantilever design length.
over 7 years ago in BC FastPlan 0

Send to BCCALC intergration

As a User, I would like to send single member designs to BCCalc in BCFastPlan.
over 7 years ago in BC FastPlan 0

BCFloorValue integration into Software

As a User, I would like to run BCFloorValue in BCFastPlan
over 7 years ago in BC FastPlan 0 Planned