Skip to Main Content
Software Ideas

Welcome to the Boise Cascade Engineered Wood Products Software Ideas Portal! 

We welcome your EWP Software suggestions and ideas.

ADD A NEW IDEA

BC Calc

Showing 6

add capability of sister ie 2x12 with lvl products together for joist repair

No description provided
over 2 years ago in BC Calc 1 Will not implement

Add walls to members that can be sent from BC Framer to BC Calc.

Wall design is not enabled in BC Framer, but is in BC Calc. Framer already has tools to input openings quickly, so it would be helpful to take these walls and send them to Calc for tall wall design.
over 3 years ago in BC Calc 1 Will not implement

Add the partition load option back into the area loadings

You had it before and it is very useful. If the user did not need a partition load you just set it to 0
over 4 years ago in BC Calc 1 Will not implement

When applying a point load above a beam that sits on a post I would like to be able to input the square inch area above. For instance if the load above is a 3.5"x14" versa lam column.

Inputting surface area for point loads above.
about 5 years ago in BC Calc 1 Will not implement

I-joist slope cuts....

Why is there a i-joist slope cut detail in Framer (detail F14), but yet BC Calc will not allow you put the slope cut in an i-joist?
about 6 years ago in BC Calc 1 Will not implement

Link one member support to more than one member

I want to link the support of one member to more than one supporting member to model the case where a run of otherwise identical joists have a different support condition.
over 6 years ago in BC Calc 1 Will not implement